Myalarm V-LCD1 Manuel d'instructions télécharger pdf (Page 97)

LCD PROGRAMMING - ADD/CHANGE KEYPAD CODES

8-91

System 2 Installation / Programming Manual

Users Enrolled 0000 þþþþ

Want to Continue? [ 1 ]

Add or Change User (Option #8)

You must first Select Card Type (Option #4) - if using cards, and Port Configuration (Option

#5) before adding or changing any users. Why? Well the System default is for a Keypad Only,

a momentary time of five seconds, and no time schedule. If you are using Readers, the System

will not request your Card Number. Instead it will request your code number. If you are using

Keypads and these defaults are OK, you do not need to Program the Ports.

If you are using Keypads exclusively, follow the instructions under Enrolling Keypad Codes.

(Below).

If you are using Wiegand, Proximity, Bar Code or Mag-Stripe Readers, follow the instructions

under Enrolling Cards

If you are using Data Chips, (which are not sequentially numbered), follow the instructions

under Enrolling Data Chips.

Enrolling Keypad Codes

In this option, you'll specify a user’s code, the door(s) the user may access, when the user may

access these doors, which outputs will be activated, whether the user is subject to Anti-

Passback, and if the user is Permanent or Temporary. Whew, that’s a lot of information, but

we’ll cover each item in detail.

System Status

When this Option is entered, you will be told how many users are enrolled and how many user

slots are available for programming:

Scrolling Options: Users Remaining 0413

1=Yes, 2=No

If you wish to enroll users press 1 (YES) and # (enter), otherwise, enter 2 for No.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 335 336

Pas de commentaire

Myalarm V-LCD1 Manuel d'instructions Page 97