Myalarm V-LCD1 Manuel d'instructions télécharger pdf (Page 91)

LCD PROGRAMMING - PORT CONFIGURATION

8-85

System 2 Installation / Programming Manual

WARNING! þþþþ

Press Any Key

1=ANY Card/Chip Mode þþþþ

Select Mode [ 2 ]

1=Yes, 2=No

Are You Sure? [ 2 ]

Selecting Any Card/Chip Mode

In this mode, any Corby Cards or Data Chips will activate any of the doors, regardless if the

card or chip is programmed into the unit. All someone needs is a Corby card or data chip and

the door can be accessed. This should only be used in minimal security applications where

security is not strictly enforced. In other words, this can be classified as an unlimited users

mode. Remember, this option will not function unless the port(s) are programmed for card use.

This should only be programmed if you desire the above outcome. Otherwise, skip over this

part of the program.

The LCD will scroll the following instructions:

Scrolling Options: This Mode Allows ANY

Card/Chip Access!

Press Any Key.

The LCD will scroll the following instructions:

Scrolling Options: 2=Normal Mode

0=Quit

You are given the opportunity to change your mind or verify your initial selection. If you select

2 “Normal Mode”, you will return on-line and the system will set the port to normal mode.

If you select 1 “ANY Card/Chip Mode” you will see the following prompt:

After making your selection, you will return to the main menu.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 335 336

Pas de commentaire

Myalarm V-LCD1 Manuel d'instructions Page 91