Myalarm V-LCD1 Manuel d'instructions télécharger pdf (Page 218)

PC/VDT PROGRAMMING - BATCH ENROLL KEYPAD CODES

9-212

System 2 Installation / Programming Manual

Batch Enrolling Keypad Codes

System Status

When this Option is entered, you will be told how many user slots are enrolled and how many

users are available for programming:

Users Enrolled 0000

Users Remaining 0413

1=Yes,2=No

Want to Continue? [1]

User Number

The first thing to do is enter a user number. This number uniquely identifies a user and can be

thought of as an employee number. When the user enters a code and/or Card, and this event is

printed or displayed on the VDT, it is not the code number that is displayed to identify the user

but the user number. This is for two reasons. First, if Keypads are used, it would be a breach

of security to print a user's code where unauthorized individuals may eventually see it. Second,

when using Cards or Data Chips, this number may be quite long, and take too much space to

print or display. At this point we will enter the starting user number. This will be the user

number that is assigned to the first user in the batch. The System will sequentially add to this

number for each user in the batch. For example, if user number 1 is selected and the Number

of Users is 20, user numbers will be 1 - 20.

The VDT will display the instructions:

Use Up to 4 Digits

0=Quit

First User # [____]

At the First User # [_ _ _ _] prompt, enter the desired number and ENTER.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 335 336

Pas de commentaire

Myalarm V-LCD1 Manuel d'instructions Page 218