Myalarm V-LCD1 Manuel d'instructions télécharger pdf (Page 196)

100

101

PC/VDT PROGRAMMING - AUXILIARY OUTPUTS

9-190

System 2 Installation / Programming Manual

As discussed above, various system events can be assigned to operate auxiliary outputs. Some

events will trigger outputs only locally on the unit on which they occur, while other events will trigger

outputs both on the unit they occur and on the master as well. Bear in mind, however, that the unit on

which an event occurs and the master may be one in the same unit (i.e., it happened on the master

and not on a slave).

If programmed to trigger outputs, events deemed important to system reliability or security (in our

opinion here at Corby) trigger both on the unit on which they occur and on the master. Other “lesser”

events trigger outputs only locally on the unit on which they occur.

The table below specifies the behavior of each of the triggerable events.

Event Type Local Only Both Master and Slave

System Reset X

AC Off X

AC On X

Door Ajar X

Door Closed X

Forced Entry X

Valid User X

Inv X

PIN Error X

Sched Error X

Request to Exit X

AP Error X

Door Perm X

Mem Clear X

Zone On X

Zone Off X

Slave Down X

Net Noise X

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 335 336

Commentaires sur ces manuels

Pas de commentaire

Myalarm V-LCD1 Manuel d'instructions Page 196

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Myalarm V-LCD1