Myalarm V-LCD1 Manuel d'instructions Page 262

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 336
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 261
PC/VDT PROGRAMMING - BACKUP-RESTORE
9-256
System 2 Installation / Programming Manual
Backup-Restore (Option #19)
This option lets you backup all data to a disk and then restore it, should the need arise (memory
loss, circuit board replacement, etc.). Corby supports the Windows
®
Terminal Emulation
program.
Refer to Chapter 9 to configure the terminal emulator.
You must have a PC to use this feature.
The display will look similar to this:
XMODEM Backup-Restore
1=Backup Sys 2
2=Restore to Sys 2
0=Quit
Enter Selection [ 0 ]
At the Enter Selection [0] prompt, make your selection.
Note: When using the backup and restore feature the XMODEM protocol MUST be used.
Backup System 2
This lets you backup all programmed information to a floppy disk or your PC’s hard drive.
After you have selected 1-Backup Sys 2 you will be prompted:
Begin your "Receive Binary File..." from the Transfer menu.
U Select Transfers from the pull-down menu at the top of the screen
U Select Receive Binary File...
U Choose the drive where you wish to backup the information.
If backing up the information to your PC’s hard drive, choose a directory.
U Type the file name.
U Single click on OK.
Vue de la page 261
1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 335 336

Commentaires sur ces manuels

Pas de commentaire