Myalarm V-LCD1 Manuel d'instructions télécharger pdf (Page 89)

LCD PROGRAMMING - PORT CONFIGURATION

8-83

System 2 Installation / Programming Manual

1=Latching, 2=Momentary

Relay Type [ 2 ]

Use 1 thru 255 Seconds

Momentary Time [ __5]

There are a couple different scenarios you may want to consider:

- If you are going to use a Keypad exclusively at this door, select 1.

- If you are going to use a Card Reader exclusively at this door, select 2.

- If you are going to use a Keypad and Card Reader at this location, select 3.

- If you are going to use either a Keypad or Card Reader at this location, select 4.

If you want to choose card options 2, 3, or 4, and you have not used Main Menu Option 4 to

configure this System to accept a Data Chip or a specific Card type, you cannot continue in this

Sub-Menu.

The System sees and treats Data Chips exactly the same as cards and therefore, a Data Chip is

always considered a card by this System.

Relay Type

When a valid code is entered, the Port’s door relay may be activated. How it will be activated

is what we are interested in here.

There are two modes of relay activation: Momentary and Latching. In Momentary mode, the

relay closes for a programmed time period ranging from 1 to 255 seconds.

Note: The main relay time for a two-door System 2 (2016) is 65535 seconds (18.2 hours).

In Latching mode, the relay toggles its state. In other words, if the relay was on, it turns off...

if the relay was off, it turns on.

The LCD will scroll the instructions:

At the Relay Type [ 2 ] prompt, pick the desired option followed by # (enter).

Momentary Time

If you chose momentary, the LCD will scroll the instructions:

At the Momentary Time [ __5] prompt, enter your selection followed by # (enter). If you

selected Latching, you are finished, you do not need to enter a Latching Time. As you can see,

you do not need to enter three digits here. A 5 is all that is needed to program this Port / door

for five seconds.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 335 336

Pas de commentaire

Myalarm V-LCD1 Manuel d'instructions Page 89