Myalarm V-LCD1 Manuel d'instructions télécharger pdf (Page 73)

LCD PROGRAMMING POWER-UP MESSAGES

8-67

System 2 Installation / Programming Manual

WARNING ! ! ! þþþþ

Clear Now? [ 1 ]

Initializing . . . þþþþ

Power-up Messages

Scrolling Options: Memory Corrupt!

1=Clear Now

2=Clear Later

If this is the first time you are powering the unit press 1 to clear memory and initialize system

settings to their default values. If the unit has been up and running, and the LCD says that

memory is corrupt, you must clear memory - at least eventually. This situation may occur as a

result of a large power surge or a poor ground. If this message appears during the course of

operation, it may be possible to “limp along” until the end of the day when system traffic is

reduced. In this case, you can press 2 and clear memory later in the day when the unit will not

be in use.

After making your choice, the LCD will scroll the following:

Scrolling Options: Please Wait . . .

Version 5.1

Press Any Key

You will now be prompted to “Set up” the Systems configuration.

Start the Initialization Process

When you apply power the first time, the System CPU must arrange your System 2 Memory

Allocation Tables.

First you can select the amount of events the System 2 will buffer, or store, in memory. These

stored events are then available to you for display should you want to view the system history.

The maximum amount of stored events your System 2 can store depends on the amount of

memory you have purchased. If no additional memory has been installed, the upper limit is 315

events. If an additional RAM memory chip is installed the upper limit is 6,013 events.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 335 336

Pas de commentaire

Myalarm V-LCD1 Manuel d'instructions Page 73